SENSOR-BASED MONITORING AND DIAGNOSTICS OF THE TECHNICAL CONDITION OF COTTON PROCESSING TECHNOLOGICAL LINES

Authors

  • Asliddin G‘anisher o‘g‘li Maxmadaminov . Author

Keywords:

Keywords: mechatronics, cotton processing, technical condition, monitoring, diagnostics, sensor, actuator, microprocessor control, automation.

Abstract

This paper presents a comprehensive investigation into the monitoring and diagnostics of the technical condition of technological equipment deployed in cotton processing enterprises using mechatronic systems. During operation, machinery is subjected to mechanical stress, high vibration, thermal buildup, fluctuating electrical drive loads, and mechanical wear, all of which degrade overall processing efficiency [1]. To supervise and mitigate these phenomena, a mechatronic monitoring architecture is proposed, integrating high-precision sensor nodes, a microprocessor-based controller (PLC/MCU), executive mechanisms (actuators), and algorithmic diagnostic routines. The proposed framework enhances operational stability and reduces maintenance expenditures.

References

1.Obidov, A. A., Khamidov, S., & Abdurasulov, A. (2022). Investigation into impurity separation via fiber loosening on the cylinder sections of fiber separators. Journal of Mechanical Engineering Science and Technology, (1), 340–348.

2.Obidov, A. A., Abdurasulov, A., Khamidov, S., & Atamirzaev, Z. (2021). Improving the fiber separation device from fibrous waste. Journal of Hunan University (Natural Sciences), 48(12), 2126–2136.

3.Mobley, R. K. (2002). An Introduction to Predictive Maintenance (2nd ed.). Butterworth-Heinemann.

Downloads

Published

2026-10-30